Kall fusion

Cooling Method
Cold air may be blown to both Reactors through their isolation if the maximum
safety temperature level as defined in the test protocol is reached in the active
Reactor.

Measurement Methodologies
1. On Heat Energy and COP
Differential Thermal Analysis:
Following the test run, the Temperature/Time logged plots of inner and outer
thermocouples will be used to calculate:
The difference of integrals between the Temperature/Time logged plots of
inner thermocouple measurements of the two Reactors. This results to the
calculation of the absolute excess heat energy produced by the active
Reactor.
The difference of integrals between the logged plots of each pair of inner and
outer attached thermocouples attached to each Reactor.
The difference of the respective energy of the absolute excess heat energy
produced by the active Reactor versus the total electric energy consumed by
the active Reactor (heater and controls). This results in the COP of the active
Reactor.
Reactors will be weighed before and after testing.