Citat:
Ursprungligen postat av
Kennethkvarting
Då vet jag faktiskt inte hur det blir. Ett filter kan vara konstruerat så att det parallellkopplas med högtalaren det ska filtrera, har du ett sånt filter blir det nog så som du sa från början att det blir 2 ohm på varje kanal.
Hittade en förklaring på ett annat forum gällande samma problem jag står inför:
" Just use a passive high-pass crossover (which you should be doing with any tweeter system anyway) and wire the speakers in parallel. A crossover presents a very high impedance to frequencies below its crossover point, so for those frequencies, the total impedance remains close to the 4 ohms of the 6 3/4" speaker. Technically the higher frequencies above the crossover point will still present a 2-ohm load, but a relatively small amount of power is required for the high frequency drivers, so it won't cause a problem for the head unit.
To sum up, as long as you use the right crossover with the tweeters, you shouldn't run into any impedance problems with the head unit."
Så det ska förhoppningsvis gå bra att koppla en liten diskant parallellt med en koaxialhögtalare.